Air Fin Cooler - Design

Job Description

Job Summary Responsible for the complete Thermal sizing and Engineering of the AIRFIN COOLED HEAT EXCHANGERS ensuring compliance with Process requirements, International Codes, Standards and relevant Customer specifications. Responsible for the complete coordination during the engineering phase (Pre bid and Post bid), within the department, with the inter disciplines, for the successful execution of the Manufacturing of the Equipments. Key Responsibilities To review the Client specification and understand the Scope of work, Technical (Design and Materials) requirement, and any criticalities therein. To carryout Thermal design at the Proposal stage to meet the Specification requirements and provide the required information to Estimation/Engineering. To optimize the design for performance, reliability, and cost, adhering to Project required Specification and Standards. Should be able to design all configuration (selection of Number of Bays and Bundles) using the Xace, Xvib. Should be able to effectively work on Fan and Motor selection, based on the client specification with optimised sizing and costing. Basic Knowledge on the Electrical and Instrumentation requirements. Should have basic knowledge on the thickness calculation of the header boxes, Nozzles and other components. Should be able to complete the structural design requirements for the Equipments. To coordinate with the Client for the successful closure of the Technical Queries (before PO). To carry out the detailed thermal design as per the agreed contract with the client (after PO), and ensure sizes are not exceeding the details done during the proposal stage. To coordinate with the Mechanical team to ensure the feasibility of the Mechanical design and Fabrication. To coordinate with the Engineers / Designers, during the detailed engineering phase to align the design with thermal and Mechanical. To coordinate with the Engineers / Designers and provide input for the drawing preparation. To check and ensure the drawings, prepared by the Designers are meeting the Thermal design and ensure the performance of the Equipment. To strictly ensure the Project schedules, are honoured without any delay, for the deliverables. To ensure timely close out of the Engineering / Procurement / Fabrication queries that shall not stop the progress on the Project. To ensure the Statuary approvals, if any are obtained on time, to meet the progress of the equipment. To have good coordination with the client counterpart for the timely close of the approvals, deviations and any other requirement. To maintain the internal progress of the deliverables and the approval status. Maintain thorough design documentation, including calculations, reports, and specifications. Prepare technical presentations for management and clients, explaining design choices and project progress. Other Responsibilities Should be able to work as a team. Should be able to adapt Departmental Work Instructions. Should be able to communicate well within and outside the department as per the need. Should be able to understand the company IMSP requirements and meet the same. Should be able to contribute to Kaizen requirements. Should be able to travel (Domestic / International) to client place for any discussions / meeting (Pre and Post Bid). Strong problem-solving, leadership, and communication skills. Adhere to the departmental KPI / KRA. Should be willing to contribute to the departmental development and any New product development as and when required. Techncial Expertise Required Good and proficient knowledge required on the below Codes and Standards.  ASME  TEMA  API  IBR Good and proficient knowledge required on the below Software / Applications.  HTRI – Xace, Xvib,  HTRI - Optimiser  Basic Knowledge of INVENTOR / Auto CAD  Basic Knowledge of PVELITE  Basic Knowledge of FEA  MS OƯice  Adaptations of ERP and PDMS systems Qualifications EDUCATION Bachelors in Engineering / Technology, CHEMICAL ENGINEERING PETROCHEMICAL ENGINEERING Experience 8+ Years, in the above Key responsibilities, worked in the Manufacturing Unit of Process Equipments Show more Show less