50 Reviews in Induskart Engitech
M
Minni Rai
Boiler tube arrived in proper condition, ends covered and no rust. Measured ID and OD — both accurate. I’m using it in high temp zone and till now no complaint. Feels thick and strong.
A
Aditya Khadke
I don’t usually write reviews but this weld union was too good. Clean edges, perfect for tig weld. I ordered 3 but I got 4… maybe by mistake but I’m not complaining. Packaging was tight too.
N
Neeraj Agnihotri
Was building a pressure test setup and needed exact orifice flange. Induskart sent me one with correct bore and bolts. Even gave the calibration sheet on email when I asked. Service was cool.
A
Anima Agarwal
Got a reducer tee to fit 2 inch to 1 inch PVC line, and the alignment was perfect. Had to hammer a little but seal is good and no gap seen. Better than what I got from local stores.
s
shivam rai
Rubber hose came with proper fittings crimped on both ends. It handled the air pressure from compressor very well. I used it for cleaning unit lines and it doesn’t kink or crack even if you fold it a bit.
s
shreyansh singh
Very hard to find full SS304 anchor bolts but finally got from here. Others sell 202 sleeve and call it 304. This one’s full SS for sure. Holding strength was good, no loosening after fitting. Threading was clean too.
L
Lakshya Singh
We use blind flanges in testing line setups and this one was exactly machined on both sides. Didn’t expect such finish in this rate. I checked with vernier and the measurements were almost exact. Happy with this quality.
R
Rahul Chaubey
Slip-on flange came with perfect thickness mentioned as quoted. Honestly I was impressed because usually suppliers say something and send something else. This time got what I expected. Flange sat perfectly, no gap, machining was clean.
Y
Yuvraj Srivastava
Helmet is very sturdy and fits well. Adjustment knob works smoothly. Been using it on-site daily, even under harsh sun, still no cracks. Color is also not fading fast which is good for outdoor use.
S
Shreyansh Singh
Tried this spiral gasket for a flanged joint, and honestly, it sealed it tight from first go. No re-torque needed. It withstood temp and pressure nicely. Got it at better rate than market.