PLC Programmer

Detail-oriented PLC Programmer with 2–3 years of experience in industrial automation, machine control, and electrical design. Skilled in developing PLC logic, configuring automation components, preparing electrical schematics, and selecting appropriate components for project BOMs. Proven ability in troubleshooting, commissioning, and optimizing automation systems across manufacturing and process industries. Strong understanding of industrial safety standards, panel design, and field instrumentation.

Key Responsibilities:

• PLC programming and debugging using Siemens (S7-1200/1500
• TIA Portal)
• Allen-Bradley (CompactLogix / ControlLogix)
• or Mitsubishi GX Works.
• HMI design and development using WinCC
• FactoryTalk View
• GT Designer
• etc.
• Experience with VFDs
• servo drives
• contactors
• relays
• timers
• analog/digital I/O modules. Electrical Design & Documentation
• Preparation of electrical drawings using EPLAN
• AutoCAD Electrical.
• Development of control circuit diagrams
• panel GA diagrams
• wiring diagrams
• terminal block diagrams
• load lists
• cable schedules
• loop diagrams.
• Understanding of electrical standards (IEC / IS).
• BOM Preparation & Component Selection
• Selection of PLC modules
• power supplies
• relays
• MCBs
• contactors
• transformers
• sensors
• switches
• protection devices.
• Sizing and selection of VFDs
• motors
• and control panel components.
• Preparation and verification of Bill of Materials.
• Vendor coordination for component comparison. Commissioning & Troubleshooting
• Installation
• testing
• and commissioning of automation systems.
• Troubleshooting PLC logic
• field instrumentation
• sensors
• wiring issues.
• Performing FAT/SAT and preparing commissioning documentation. Industrial Communication
• Knowledge of Modbus RTU/TCP
• Profibus/Profinet
• Ethernet/IP
• RS-485/232.
• Network configuration and device integration.

Skills Required:

• Designing
• programming
• and testing PLC logic.
• Developing HMI screens.
• Preparing electrical schematics.
• Creating BOMs with correct component selection.
• On-site commissioning and troubleshooting.
• Updating as-built drawings.

Qualifications:

Diploma

Additional Skills:

• Assist senior engineers in robot installation and commissioning at customer sites.
• Participate in robot programming
• path teaching
• and cycle optimization tasks.
• Support preventive and corrective maintenance of robotic systems.
• Perform wiring checks
• tool alignment
• and safety verification during commissioning.
• Document installation reports
• test results
• and troubleshooting activities.
• Follow safety and compliance procedures during all site operations.

Personal Strengths:

Strong analytical and problem-solving abilities – High attention to detail – Good communication skills – Knowledge of industrial standards – Quick learner and proactive